Trigger Wheel from NST (www.NonStopTuning.com)

dr.occa · Post by **dr.occa** » Fri Apr 20, 2007 2:08 pm

I wasn't sure if this was an appropriate location to post this up, but for other 4AGE drivers, NST mounted my trigger wheel onto one of their underdrive lightened crank pulleys (with some slight modifications). The owner is a friend. Since he's been more than kind and generous to me in regards to my project(s) I wanted to possibly give his company and services more exposure. NST can also do custom pieces and they're all done right here in the US. Anyway, I'm very anxious about getting the megajolt wired upto the car all the more. Here's a picture of the mounted trigger wheel:

*note: i didn't notice that this was my first post! i haven't much to contribute being that my mjlj isn't installed yet (assembled and tested good) but will soon. the wire harness is where i'm dragging my feet...

Post by **brentp** » Fri Apr 20, 2007 3:31 pm

Hi, Normally we don't allow 'commercial advertising' for obvious reasons (see forum rules) but as others have pointed out, it would be very useful for people to know where to find parts to complete their ignition setup.

I'll move this to the 'for sale' forum, and then re-cast that forum to be more suited for 'where to find parts to complete your MJLJ setup'.

Thanks for your contribution!

dr.occa · Post by **dr.occa** » Mon Apr 23, 2007 3:40 am

brentp wrote:Hi, Normally we don't allow 'commercial advertising' for obvious reasons (see forum rules) but as others have pointed out, it would be very useful for people to know where to find parts to complete their ignition setup.

I'll move this to the 'for sale' forum, and then re-cast that forum to be more suited for 'where to find parts to complete your MJLJ setup'.

Thanks for your contribution!

brentp i appreciate the patience and i appreciate Megajolt Lite! i have very very few posts being that i've no insite to contribute (hopefully yet) and i'm just an acolyte here.