AEM Engine Position Module

matthepcat · Post by **matthepcat** » Tue Jul 25, 2017 5:59 pm

Can the AEM Engine Position Module be used to capture signal as an alternative to a trigger wheel with Megajolt?

See here: http://www.jegs.com/p/AEM/AEM-Engine-Po ... 5/10002/-1

It uses a 24 to 1 tooth pattern, and has both hall effect cam signal and hall effect crank signal output.

I know that this cannot drive drive ignition coils directly.

Thanks

Post by **brentp** » Wed Jul 26, 2017 4:56 am

Hi, Unfortunately this will not work with the Megajolt system. It must use the VR sensor for the Ford EDIS module.