Autosport Labs

folks

I have a Mk3 and a Haltech 1300

I have the Haltech harness and I have connected

Haltech Mk3
Blue Can 2 high to Can 2 high
Blue/whit to Can 2 low
Orange white to And

12 v not connected

When I run the script to see if any data . nothin ( scripts been changed to use can )

Stop one can anyone confirm pinouts for Haltech elite to a Mk3 ?

Did you figure this out yet? You may want to double check:

* CAN high / CAN low wiring
* Termination is enabled on both ends (RCP MK3 is software controlled, under setup)
* Baud rate is identical on both ends
* CAN output is enabled with the Haltech

We have a generic CAN bus logger that will show if anything is being read from the CAN bus:
https://wiki.autosportlabs.com/CAN_Bus_logger

Hope this helps, please let us know what you find out: