V2 Questions

[Iainb]

Hey guys, just got a pre made V2 board 2nd hand to play around with. It comes with bits of loom but im still slightly confused with tps, etc.

How do i know if it is TPS compatable? there is no map inlet so im asuming its tps? if so are the connections the same on the molex plug as v3 board?

next, im planning to run a set of zx6r bike carbs complete with built in tps, will this be compatable? what should be resistances be?

any info would be great, iv got megatune working so i might try to communicate tomorrow...

many thanks, Iain