Autosport Labs

Congratulations

Our son Marcus Alexander was born 1/12/2010 weighing 7lbs 14oz

Battery Angle Grinder, is what I used! :oops: You might find the screws have rusted into place, I just cut around the mounts, and ground the head off the crank sensor as I remember it being a Torx. Depends on the scrap yard policy on damaging other components, mine doesn't care. I watched people wit...

Well done.

We're less that 2 weeks away from the due date for our first.

Great timing, seeing as we currently have several inches of snow on the roads.

brentp wrote:Received some brand new board designs today. Can you guess what they're for? One should be easy..

Well going from the names, Launch control, Interceptor -> Canbus interface ?, Race Capture, Injectx -> Fuel injection controller -> Megasquirt style.

I run the set up in the diagram (It was me that posted it originally) for quite a while, with no problems. I later fitted one of the Beta test rev limiter and modified it to power the coil pack from the MJ unit. But still the earths are wired as shown, the actual connection is a ring terminal betwee...

I fitted my trigger wheel in the same way, well apart from Liquid nitrogen as a coolant. They also machined on a slight taper to the crank pulley and trigger wheel (you can't see it by eye), this means that when fitted you would need it to expand to come loose. The original Sierra wheel is fitted th...

You could also catch this the next day nearby.
Thats where I will be.

You most definitely need resistor plugs, see the problems I had here
http://www.autosportlabs.org/viewtopic. ... ght=#12192

I have NKG BRP6ES the alternative is Champion RN9YCC

Knew I had seen that type of setup before somewhere.

So the 2nd diagram is correct. Here's a photo of the assembly

So its sensor/bracket/plate
The sensor can be spaced backwards with a washer if needed.

Or if thats too far forward try this way

I would say its a clamp to spread the pressure of the bolt.

So it goes like the poor Paint picture attached

How close mine is

I would say that's miles too far away.

I set mine with a feeler gauge at 1/64 of an inch approx 0.5mm

Can it be mounted the otherside of the bracket ?

Seems I make the top 20.

In at number 14

There is no cover, just drilled the face of the gauge and mounted behind.