Autosport Labs

Just give a shout when you are ready.

Nice looking mini.

Hi Ryan Thanks for the comments on the mini. The mini only gets used for runs, shows, track and for a blast round the mountains. My daily drive is this http://i7.photobucket.com/albums/y253/swdonnelly/DSC_4497.jpg If I am around then I am always open. It good to here you will have your mini on the r...

This is my mini. A 1968 Cooper S MK11, I have been running Megajolt for over 12 months now and all has been great The spec of the car is as follows Engine size: 1275cc Cylinder Head: MED Rally, with 37mm, 31mm vales, 180 pound double race springs with magnesium bronze guides. Gas flowed, ported and ...

Looking good keep up the good work

I could look into a Rolling Road you for you.

computers have never been my thing really. I am lost

The voltage outputs on the voltags regulator are left = 4.95 mid = 0 right = 7.66, I have the megajolt conected to 9v battery, on the U1 as per the assembley guide I have 4.95 on pin one and ground as the photo. The voltage from pin 4 if I have it right is 4.91 volts. Hope this helps

I was unable to flash the firmware as the computer can't see the megajolt. The coil was not on the car when we fitted it. Will test the voltage supplies in the morning and let you know the results. If I need a replace all the chips can I get them from here.

Thanks for your help so far.

nice car

still no go.

will try and let you know thanks

The tach is a standard Rover Mini 3 clock tach. In the other car it was running on a aftermarket tach with no problems.

The advance was just on limp home mode, if you disconnect the megajolt the car just stayed the same.

How do I reload the firmware?

Thanks

Hi I am running V4 controller and a MAP version. The unit was running before great. The ULN2003 was visibly damaged. Only using the tach out. The wiring is all ok as we tried a friends megajolt which worked fine. On the megajolt which stoped working we did connect a tach to it, on the second megajol...

Over the weekend I fitted my megajolt to a other car. It powered up ok. But would not talk to the laptop, and the car was running on the edis not the megajolt. I have looked in side the unit and the Ic1 uln2003 transistor had burnt out, which I have now replaced, Still had no joy in getting it to wo...