Autosport Labs

Thanks, lot of people tell me that and it's problem for shure. I will do today and put some stronger profile of steel and try to make some triangle from two bolts and VR sensor. i will lett you now how progress.

Here is mine map and I dont now does it right becouse my car have some misfire at 2-3K RPM. Can somebody try to repair if now how

When I pull full trottile its go like crazy, if I pull trottle slow its has misfire and stop-go thing.

Eny sugestion?

Why you think that, it's just temporarly solution not for long time. When engine is working it's have little much move, also in OEM setup in intake side thare is one strut thay hold Intake maniflod so that can just help with stabilize engine.

Thanks, the sensor bracket is very strong its 4mm steel. When I sty and Idle and give trottle I watch on monitor and look how advance is progres. I dont see that advance has some stumbling. Also when I drive and pull full trottle nothing stumbling, go perfect, also when I pull slow trottle go perfec...

And couple more...

Here is my complete setup. I have little problems but everything is solved accept jeting. I have little more air then fuel and in lower RPM is little unstable, but hope I solve that in couple days ahead. Hope you like it

:D :D :D I solve the problem, After to much trying to make it alive I do one easy thing, re-solder every connection and joints in MJ becouse I see that some joints are little thinky and no good contact. After that I make to connect MJ with PC without problem and put some mapp, and in other hand its ...

Yes i have power on the voltage regulator, also I have power on electrolytic capacitors, transceiver, transistor... I recive PIP signal from Edis but dont come nothing from SAW. What part directly make SAW signal, mybee I must to focus on that and try to solve?

Today nothing new, I dont have SAW signal from MJ and everything about wiring is set corectly, Put cable with shild and ground on one side (neart EDIS), and still not working. Also I use voltmeter to check does everything about parts inside are ok. Everything is on good value exept one thing, 1N4742...

So the unit come in kit from you and my friend bougt it and make it run. Test on bench and put some maps for Pinto 2.0. Newer working in car just tested on bench. Becouse He dont need any more ( change setup) He give me that unit, so it's like new and newer working in car. Past days I spend lot of t...

First I read every post on this forum and try to find solution for connection, but it can't be at all. I have V3.0.0 Megajolt and I do everything. I have serial to serial cable and USB to serial( Profilic) and nothing happend in bouth connection. I connect MJ to batt, and then to COM1 with Serial/se...