Autosport Labs

right got yeah, nice one but i thought that you could fine tune the timing up to a few degrees, im not sure if its right as the motor still runs for a few seconds after i switch it off?

Hi Long time since the last post but i had my engine rolling roaded for the first time around a month ago just to get the basic settings so i could run the engine in, it managed to get 111bhp at 5750rpm as its been limited to that until iv do around 1000 miles, im really pleased as he said that ther...

Hi

How do i check cracking advanced on the megajolt software, and how do i adjust it and what too?, i know thats a lot to ask but the engine it not running smooth at all

any help would be appreciated

thanks
Rich

HI

sorry for the late reply, but its in the top of the manifold im running twin HS4's so it in the middle of the balance pipe on the manifold, its none turbo

Rich

HI had my engine running now for a while and I've noticed that the map pipe fills with fuel vapor (fuel) over time how can i stop this? iv had my car rolling roaded so it's not over fueling, im wondering if its where I've tapped into the manifold, if anyone has had this before any help would be grat...

Hi
I'm running my engine in for the frist time and iv noticed a problem my map pipe to my jolt squashes when I'm reving it, can anyone recomended the pipe I should use?

Thanks
Rich

Thats just what i was looking for nice one

Rich

Hi all I need help adjusting my map due to the rolling road guy, he will tell me what to put in but he's not willing to do it himself :( iv put a base map which is a close spec to my engine but i have a feeling it will need adjusting on the rolling road and i don't know how to do it, can anyone tell...

Thanks guys il try and have some videos up soon of it running, at tho mo it runs but its a bit dodgy, il aslo get some pics up where iv mounted the megajolt module too.

Rich

My 1380 spec A+ block board to 73.5mm •Megajolt ignition system •Twin HS4's •ported and polished cylinder head 36mm inlet 31mm exhaust center main strap •Billet 286 kent cam and followers •lightened steel flywheel and back plate •orange clutch with upgraded friction plate •1.5 high lift roller rocke...

Hi Ryan Thanks for looking for me il try the spi2 map to see if that will work for me, at the mo im running the aldon yellow map but not sure if its doing it any good as im running my engine in still. Yeah il post some pics, iv posted a few on the minifinity website i reconise your name from there l...

Need map for this engine asap please if anyone can help?

Hi there

i have the same rev counter as you how did you wire it up to work as mine just sits there!

Hi Im Richard and iv just built myself a 1380 spec below •Twin HS4's •Slark SF4 cylinder head •1380 block with centre main strap •Billet 286 kent cam and followers •lightened steel flywheel and back plate •orange clutch with upgraded friction plate •1.5 high lift roller rockers •swiftune Alloy Duple...