Autosport Labs

Hi Vladimir. I was never able to open the MAO. Can you resend it to me at john@hortontv.com in PDF form. I ain't good at computers. Thanks. Since I wrote I leaned out the carbs and now have a light brown tip on the electrode and grounds. I checked the lineup of the timing belt cam pulley's and marks...

I found one problem. Fuel pressure on the side draft carbs is important. PLus they are racing carbs and not tractable for street use. They want to go from idle to high acceleration with very little mid range. I will go thru the MAP and see if I can make slight changers that can effect the midrange. ...

Vlladimir. I have the same setup in a Locost seven. I am having backfiring when I let off the peddle. Plus slow acceleration. Can we talk johnehorton@yahoo.com I am in Phoenix AZ Can you send me the MAP in a PDF form. So I can compare it to the one I am using. What jetting did you use and where do y...

I am having a problem. My Locost 7 is now complete and running. It is a Toyota 4AGE and two dellorto side draft 40MM carbs. Plus the megajolt lite I am having slow acceleration and lots of backfiring. Any ideas on how to solve this. Has anyone created a map so I can get a cure started. I could use s...

I am having a problem. My Locost 7 is now complete and running. It is a Toyota 4AGE and two dellorto side draft 40MM carbs. Plus the megajolt lite I am having slow acceleration and lots of backfiring. Any ideas on how to solve this. Has anyone created a map so I can get a cure started. I could use s...

Robert, Thanks. I was not certain about the position of the gap in relation to the TDC of the engine. I intend to place the sensor on the left side of the engine about 90 degrees from the TDC marking. This will actually make the gap on the timing wheel at 180 degrees to the TDC mark on the front pul...

I am using the EDIS on a toyota 1.6L 16 valve. I understand the open tooth should be at the sensor when the engine is 90degrees BTDC If that is coorect. I can place the ring with the open tooth at 180 degrees to the timing "V" on thre front pully. This way I can place the pickup on the lef...

Thanks. I thought this might be the case. I will set it up so the engine will indicate 90BTDC when the gap passes. I intend to mount the sensor on the side of the block out of way of the fan belt and alternator. John H.

I have an EDIS system and Megajolt JR. I am useing a Toyota 1.6 twin cam. Where do I posiiton the open tooth on the wheel. I am hearing 90 degrees before TDC . John

I am using a Toyota 1.6L and think the position of the wheel is only dependent on the position of the pickup. I am not using the distributor. I will use the EDIS system. If the engine timing is "O" top dead center, the missing tooth and pickup can be positioned 90degrees apart anywhere on ...

I have found an EDIS system to install on my Toyota 4AGE. I need a wiring diagram for the installation can anyone help? Diagrams, color codes and connection to megajolt would be appreciated. Framis

Can I use the megajlot jr 2.01 without a turbo? I want to use carbs and no turbo. Does it need to be changed to a vacuum sensor/ Framis