Search found 7 matches

by escortdan
Fri May 19, 2006 11:14 am
Forum: Operation
Topic: V3 board questions
Replies: 2
Views: 3675

Hi Martin,Thanks for the

Hi Martin, Thanks for the mail it is very very helpful! Yes the board we ordered was a TPS one as that works better for what we want to use. thanks for the info, was just a little puzzeled as to why it still ran but at least we know now and it's not a wiring fault or anything silly we have done! Tha...
by escortdan
Fri May 19, 2006 8:19 am
Forum: Operation
Topic: V3 board questions
Replies: 2
Views: 3675

V3 board questions

We have now a fully working v3 board that we can talk to and have mapped with a base map so far and the car has started from it. Should the car still run if the ecu becomes disconnected!? We tried this last night and the car keeps running?! Should this happen? Seems strange but was just a test to se...
by escortdan
Thu Dec 01, 2005 11:28 am
Forum: Operation
Topic: comms problem
Replies: 9
Views: 7655

Thanks Martin i have fired

Thanks Martin i have fired an email off to you!

Dan
by escortdan
Thu Dec 01, 2005 10:25 am
Forum: Operation
Topic: comms problem
Replies: 9
Views: 7655

Follow on

ok have checked and double checked the molex connector and it is wired up as per your picture. I have tried a laptop with a known working com port and still nothing! We cut a serial cable and only used the cables that were needed as from looking at the board, we got a bit further use the dos app it ...
by escortdan
Mon Nov 28, 2005 3:25 pm
Forum: Operation
Topic: comms problem
Replies: 9
Views: 7655

I have set the comms port to

I have set the comms port to the required rate, was one of the first things i tested! I will double check the pin is wired properly but it appears to be an issue with the com port, it says that it is in use all the time, but i can't find anything that is using it! I have tested it with my old modem ...
by escortdan
Sat Nov 26, 2005 9:18 pm
Forum: Operation
Topic: comms problem
Replies: 9
Views: 7655

comms problem

I am really struggling here to gget communication with the v3 ecu i have that was pre built from brent. I have installed all the java stuff several times and tried the hyper terminal and dos app but stll can't get access. I have checked the comms port, set to com 1 in the bios and in windows and it ...
by escortdan
Fri Nov 11, 2005 11:57 am
Forum: Installation
Topic: unable to connect to controller
Replies: 3
Views: 4684

Cannot connect to controller

I am having the same issue, I get an error message at the bottom saying that it can't connect to the controller, i have checked al the comm ports and it won't connect, i have tried re installing the software but has made no difference.

Dan