V3.3.1 bug found??

mr_bridger · Post by **mr_bridger** » Mon Mar 30, 2009 6:50 pm

Hi Brent,

ive not been about for a bit, been doinf some major bodywork on another car, and i only just got round to updating my V3's to the latest firmware.

As ive had the engine apart, i thought id make use for the trigger offset feature, save me adjusting the crank pulley / trigger wheel.

now when i try to "write options" i get the following error message, although it seems as though it works ok.

Laptop is very basic Pentium 3, 320mb ram, running XP, and im using a serial cable.

all updates and communications work fine, as does programming and flashing.

seems to do it in both V3.3.0 and v3.3.1 versions. (p.s. what the difference?)

Cheers
Ross.

luke6040 · Post by **luke6040** » Tue Mar 31, 2009 3:40 pm

I get this aswell but have put off posting it lol!.
Im running XP64bit, standard serial cable ect.

Post by **brentp** » Tue Mar 31, 2009 4:03 pm

Thanks, guys. I'll verify on my end. So other than the error, you are verifying the values are indeed written after a power cycle?

mr_bridger · Post by **mr_bridger** » Tue Mar 31, 2009 5:10 pm

ill have to verify that, but it certainly updates it, as i watched the timing flicking back and forth as i changed the figure.

didnt re-check after a power cycle....

will do though.

Ross.

luke6040 · Post by **luke6040** » Tue Mar 31, 2009 7:37 pm

on mine as far as i can tell the values are there after a power cycle, i will double check tomorrow tho.

mr_bridger · Post by **mr_bridger** » Tue Apr 07, 2009 9:46 am

Had a checke, and my values stay after a cycle too.

Ross.