Need a little help

General discussion on Autosport Labs, the mission, website, content, etc.

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
didly
Posts: 17
Joined: Thu Jul 12, 2007 7:41 am

Need a little help

Post by didly »

Hello, just looking for some advise concerning the upgrade of my Megajolt. I purchased the unit in 07 to transplant a zetec into a GRP 4 mk1 escort. All worked ok and had engine running on MJ with no hassles. Since then the whole setup has sat in the couboard until a couple of weeks ago while completing bodywork. Reinstalled all the ignition components and noticed that i didnt have the corresponding configuration program for my MJ. The unit is a V3.2.1 version. Can i run a later version of the configuration program or do i need to upgrade to the later firmware as well, if so is this all i need to upgrade or is there other components to install as well

Thanks Mik

Gilesy998
Posts: 144
Joined: Tue May 16, 2006 4:35 pm
Location: Liverpoool, UK

Post by Gilesy998 »

The Firmware and Configurator must correspond, there are updates in the config that older firmwares will not support. If you need to update the firmware, it's a reasonably simple process requiring a bit of DOS use, detailed in the Wiki guides.

brentp
Site Admin
Posts: 6282
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi Mik,

You can download the 3.2.1 configuration software here: http://www.autosportlabs.net/asl_dist/m ... v3.2.1.exe

Regards,
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

didly
Posts: 17
Joined: Thu Jul 12, 2007 7:41 am

Post by didly »

Thanks


Mik

Post Reply