Installing in Dodge Neon using a stock crank wheel?

[4600cc]

I'm installing MJ in dodge neon, it is a 2.0L 4 cylinder engine. It uses GM HEI ignition, and has the following trigger wheel setup:

<a href="http://www.autozone.com/servlet/UiBroke ... jsp">Click here for Neon's crank sensor information page</a>

Can I hook up EDIS-4 right up to that VRS and expect it to work right out of the box?

...and if not, what do I do? I want MJ in that thing bad!!!



AL

[Todd Charles]

No, sorry, you will need to mount an EDIS wheel to your crank. Your best bet is usually mounting to the front pulley. I think 3 different sizes are available stock. The 4cyl 1.9L is about 5 1/4" diameter. You will need to research the other two. The second rout would be to have a cusom unit built or have it machined directly into your front pully or dampner.

Todd

[brentp]

Yep, the ford edis module needs the 36-1 wheel, unfortunately.

here are some pictures of how I did it on my toyota 4AG motor:
http://picasso.org/misc/mr2/engine/
http://picasso.org/misc/mr2/engine/timi ... l_face.jpg