some pics of my install... 1965 MGB +40 18V block reworked big valve cylinder head, Nissan 280ZX 5 speed..
completed June 2010
This is a MAP type installation.
The ignition map I used came from the 'how it was done section"
so far I haven't modified it because the car runs so well. starts from cold in a few turns, and from hot the same..
Th car pulls hard through the gears and idles dead smooth!
The trigger wheel came from triggerwheels.com and it was for a A series engine. I milled the adapter so it sits 2 thou out from the pulley and I milled the pulley down to ensure the sensor reads properly.. the next one I do will simply be a larger trigger wheel...( 6 inches) so the pulley will remain standard.
There is a lot of theory that the damper shouldn't be modified, but so far I don't notice any negative vibrations etc.
The sensor is from a 2000 Ford Taurus.
I spend about 400 Cnd dollars in the install.
1965 MGB installation
Moderators: JeffC, rdoherty, stieg, brentp
1965 MGB installation
- Attachments
-
- Sensor install with a custom pulley bolt
- 1.jpg (178.39 KiB) Viewed 12221 times
-
- sensor install - the fan belt is a fiddle to get between the rack and the wheel.. but it can be done
- 3.JPG (252.52 KiB) Viewed 12221 times
-
- sensor install
- 4.jpg (145.25 KiB) Viewed 12221 times
Last edited by MGBMarty on Wed Sep 08, 2010 2:28 am, edited 3 times in total.
1965 MGB part 2
more of the MGB install
- Attachments
-
- sensor install : sorry for the fuzzy photo , but I wanted to show the general fit and the clearances
- 5.jpg (173.11 KiB) Viewed 12220 times
-
- Coil.. screwed to an old Lucas distributor cut down to size 1st glance looks stock.
- 6.jpg (219.84 KiB) Viewed 12220 times
-
- megajolt installed under dash with added blue LED to indicate power
- 7.jpg (196.47 KiB) Viewed 12220 times
Last edited by MGBMarty on Wed Sep 08, 2010 2:30 am, edited 1 time in total.
MGB part 3
3rd part:
- Attachments
-
- EDIS module installed behind glovebox
- 8.jpg (242.94 KiB) Viewed 12218 times
-
- 40 CC Vaccum stabilizer capsule made from two built in Vacuum cleaner ends.. PVC
- 9.jpg (238.03 KiB) Viewed 12218 times
-
- The car ( In Toronto Canada)
- 10.jpg (235.21 KiB) Viewed 12218 times
Last edited by MGBMarty on Wed Sep 08, 2010 2:28 am, edited 1 time in total.
-
Funky Diver
- Posts: 133
- Joined: Tue Jun 08, 2010 7:06 pm
