Log voltage off of Pin2?

sbarton · Post by **sbarton** » Mon Jun 10, 2013 8:01 pm

Is it possible to have the system log voltage and just use pin2, since that is hooked up to the power source anyway?

-Scott

Post by **brentp** » Wed Jun 12, 2013 8:01 pm

Hi Scott,

Analog channel #8 is internal and not connected to the terminal block and is hard-connected to measure system battery voltage, if I understand what you're referring to.

Just set a sample rate and select the channel name "Battery" and you're good to go.

sbarton · Post by **sbarton** » Wed Jun 12, 2013 10:37 pm

Do I need to hook a wire to analog 8 to do that?

Post by **brentp** » Wed Jun 12, 2013 10:47 pm

Nope! As before, it's internally wired and not hooked up to the terminal block. You get it automatically.