Finally I have the trigger wheel!!!

[Luca Lagonigro]

Finally I have my laser cutted trigger wheel, it took me so long to find the right supplier, that I forgot how I intended to attach it to my car's pulley.

http://community.webshots.com/photo/692 ... 6188UkNWvR

mumble... mumble...

[hotrodfil]

Presumably the curved slots are to allow adjustment of trigger position. Nice.
So, what diameter, what thickness, and obviously you had a few spares made...?! If so, how much?

[Luca Lagonigro]

Yes since I don't know yet the position for the sensor in relation to TDC I've made the slots for ease adjustment (no need to move the sensor).

In the meantime I found a solution! I taped the wheel to the pulley!

http://community.webshots.com/photo/692 ... 5826YwYeBa
http://community.webshots.com/photo/296 ... 9631VSHdpz

This file contains the thooted wheel drowing an dimension:

http://81.208.68.147/luca_tmp/wheel.pdf

And yes I have a spare one but I'll keep it until the engine is finished.

>>>> EDIT

I was billed today 17 - 03 - 2005

35 Euros each, not too bad, there is a good quntity of metal with 12mm thickness.

I think it can be made cheaper with 6mm steel.