When trying to work out my table I drove around with the lap top next to me. Many times the advance dial showed 12, 16 and 18.
And the lowest advance value I had in the table was 19. How can this be?
I enclose a screendump of the table.
I get an advance value I don't even have in the table !?
Moderators: JeffC, rdoherty, stieg, brentp
I get an advance value I don't even have in the table !?
- Attachments
-
- Table3.jpg (224.61 KiB) Viewed 2776 times
All those who believe in telekinesis, raise my hand now !
Patriq,
The flashed processor data and what was shown on the screen in the software might have been out of sync.
Next time you test this do a fresh read from the MJLJ after a power cycle and make sure your ignition map is correct. Sometimes it's easy to forget to 'flash' after 'updating' the MJLJ with new values.
If you still see problems, perform a datalogging session (datalog to file), then post a reply to this thread, attaching this datalog file along with your current .mjlj configuration file and we'll take a look at it.
The flashed processor data and what was shown on the screen in the software might have been out of sync.
Next time you test this do a fresh read from the MJLJ after a power cycle and make sure your ignition map is correct. Sometimes it's easy to forget to 'flash' after 'updating' the MJLJ with new values.
If you still see problems, perform a datalogging session (datalog to file), then post a reply to this thread, attaching this datalog file along with your current .mjlj configuration file and we'll take a look at it.
