Autosport Labs

tonci wrote:Will try it tomorrow on my new laptop but with usb to serial converter...I am going to sleep now...it is 1.42 am here and I work tomorrow at 7 am

I managed to upgrade firmware with my new laptop...3.2.1 firmware working great now ...thanks

Will try it tomorrow on my new laptop but with usb to serial converter...I am going to sleep now...it is 1.42 am here and I work tomorrow at 7 am

Yes I have followed that procedure but it stoped at this:
Waiting for HC08 reset ACK...
can it be that it doesn't work with win 98?

I've tried to upgrade to v3.2.1, but it stops at this:''Waiting for HC08 reset ACK...'' so I presume that there is no bootloader on my motorola chip ( I did buy it programed from you about one year ago). I have tried upgrade from my old laptop that has serial port but it has windows 98 (can this be ...

Hi guys, I need help asap...I can't comunicate with my megajolt with configurator v3.0.0 it does comunicate but it meses up tables every time I try to save them to controller. I had one version of cofigurator (I think v3.0.6 or something) that worked well but I've lost it together with my HD on lapt...

Hi Brent,

I am sorry for late response, when I say 'save changes' I mean saving them to the controller. I will take screen shot of the error tonight and mail it to you.

I've tried it on xp and win 98, it acts the same.

regards,
Tonci

I have a problem with configurator 3.0.0. It has a connection with megajolt, it shows map readigs, but I can't save changes that I've done in the table. Software shows error and then it closes it self. Sometimes it shows some strange numbers in table like 200.

Yes I can communicate with computer and it even shows that it is changing angle with engine rpm. I have measured voltage on saw output and it is changing in relation with angle that I can see on computer, but engine angle is allways at 10°BTDC. So it is probably EDIS modul right?

But it does work in limp mode, are you shore that that is the problem? I have good rpm reading.

Hi, I have installed EDIS with this trigger wheel: http://www.inet.hr/~artst/msavr/remenica1.jpg (one of the tooths was grind off afther the picture) and it works great in limp mode and it is rock steady at 10°BTDC, but I have a problem with geting it to change angle. Sometimes it works OK but most...

Just to let you know, it does work...

Yes you did see it right. The picture was taken before the one of the tooths was grind off.

Hi,

Do you guys know if EDIS going to work with this type of trigger wheel: http://www.inet.hr/~artst/msavr/remenica1.jpg ...it is 36-1 custom made steel wheel.

Please take a look at this picture: http://www.inet.hr/~artst/msavr/edisW.jpg and tell if everithing is OK. I don't know for what is green wire used...it says IDM on EDIS information here, but on the shematic here http://www.bgsoflex.com/mjl/sum4.jpg it is not connected...help I don't want to burn m...