shift light megajolt jnr

jimbo198966 · Post by **jimbo198966** » Thu May 26, 2011 9:04 am

hi,
how do i go about putting a shift light onto my megajolt jnr?
i've read the guide on here, but can't understand it

thanks, jimmy

Post by **brentp** » Thu May 26, 2011 3:52 pm

Here's the section in the installation guide that talks about installing a shift light:

http://www.autosportlabs.net/MJLJ_V4_ve ... hift_Light

Let us know if you have any specific questions!

jimbo198966 · Post by **jimbo198966** » Thu May 26, 2011 4:28 pm

brentp wrote:Here's the section in the installation guide that talks about installing a shift light:

http://www.autosportlabs.net/MJLJ_V4_ve ... hift_Light

Let us know if you have any specific questions!

firstly, thanks for the reply

Thats the guide i've been looking at...
i just can't get my head round, on how to wire just a single shift light up.
do i have to 'set' it via the megajolt software?
cheers, jimmy
ps i'm totally new to this megajolt/eletronic ignition lark!

spandit · Post by **spandit** » Thu May 26, 2011 6:52 pm

From what I understand, you wire a single shift light up as follows:

1) connect one end to a 12V source
2) connect the other end to the dedicated shift light pin on the MJLJ connector
3) set the shift light RPM in the software and flash to the controller

jimbo198966 · Post by **jimbo198966** » Thu May 26, 2011 7:18 pm

spandit wrote:From what I understand, you wire a single shift light up as follows:

1) connect one end to a 12V source
2) connect the other end to the dedicated shift light pin on the MJLJ connector
3) set the shift light RPM in the software and flash to the controller

ahh thats where i'm going wrong then

done, 1) + 2)
Just need to set the shift light RPM.

Are there any guides for that?

spandit · Post by **spandit** » Thu May 26, 2011 7:21 pm

It's easy - on the ignition map page (the table of numbers) there are 3 tabs. Haven't got it in front of me but click one of them and there is a box clearly marked to set the shift light and limit RPMs

jimbo198966 · Post by **jimbo198966** » Thu May 26, 2011 7:37 pm

spandit wrote:It's easy - on the ignition map page (the table of numbers) there are 3 tabs. Haven't got it in front of me but click one of them and there is a box clearly marked to set the shift light and limit RPMs

ahh nice one, found it, just need to plug it in, and check what mine is. haven't got the lead or car with me

cheers pal, very helpful guys!

Jimmy

jimbo198966 · Post by **jimbo198966** » Fri May 27, 2011 8:51 pm

it now works

i had wired it up wrong too, and the rpm was set at 7000, now at 6000, but i'm going to lower it again

thanks alot for your help guys